Hello Leaves

Hi everyone.  Time for a reminder for the CAS Mix Up February Challenge - Dimensional Die-cuts, hosted by our wonderful Hideko.

I started by die-cutting my leaf sprig three times (twice from white card stock, once from acetate to use as a stencil).  I softly sponged my leaves over the background using the stencil, changing the angle of the leaves to create a random design.  I think having the leaves in the background helps create a sense of depth.

With the two white card stock die-cuts, I sponged one completely using dark brown, light brown and rust.  The second sprig had only the leaves sponged.  I used my stylus and foam mat to add a curve to the single leaves.  Then layered them on top of the sprig, off-setting them slightly from the bottom leaves and adding a rolled glue dot at the tip of the leaf for dimension, while gluing the base of the leaf flush.

A simple white frame was popped up over the stenciled background and the layered leaf die-cut was added on top with a sentiment stamped in rust to finish.

Here's a close-up ...

... and an even closer look at the leaves ...

I hope you'll check out the challenge blog to see the amazing dimensional die-cut cards from our Designers and fabulous Guest Designer, Arlene.

Adding this to the Take It Make It Challenge - Craft Stampers magazine.  This is my second entry.

Stamps: Happy Messages (Stampendous)
Paper:  White card stock (Neenah 110 lb.)
Ink:  Distress Inks:  Brushed Cordoroy, Gathered Twigs, Rusty Hinge (Tim Holtz)
Accessories & Tools:  Leaf die (AliExpress), Sponges, rectangular die-cut for frame, stylus and foam mat

Challenges:
CAS Mix Up February Challenge - Dimensional Die-cuts
Take It Make It February Challenge